This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
laserinfo:pcb_stencils [2009/05/06 23:09] ladyada |
laserinfo:pcb_stencils [2016/01/28 18:05] (current) |
||
---|---|---|---|
Line 73: | Line 73: | ||
I usually use the Dimension layer info to make a jig for silkscreening by cutting out the PCB outline in a 0.062'' (1/16th) clear acrylic sheet | I usually use the Dimension layer info to make a jig for silkscreening by cutting out the PCB outline in a 0.062'' (1/16th) clear acrylic sheet | ||
+ | |||
+ | Here is a LFCSP 16 (4mm on each side) cut out of 2 mil kapton as above | ||
+ | |||
+ | {{:laserinfo:lfcspkapton.jpg|}} |