This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
laserinfo:pcb_stencils [2009/05/06 20:24] ladyada |
laserinfo:pcb_stencils [2016/01/28 18:05] (current) |
||
---|---|---|---|
Line 5: | Line 5: | ||
You'll need: | You'll need: | ||
- A laser cutter | - A laser cutter | ||
- | - Kapton film, I like the 1 mil thick 1 ft square sheets from [[http://www.mcmaster.com/#2271K2|McMaster-Carr]] | + | - Kapton film, I like the 2 mil thick 1 ft square sheets from [[http://www.mcmaster.com/#2271K2|McMaster-Carr]] |
- Solder paste such as [[http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=KE1507-ND|Kester No-Clean]] | - Solder paste such as [[http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=KE1507-ND|Kester No-Clean]] | ||
Line 73: | Line 73: | ||
I usually use the Dimension layer info to make a jig for silkscreening by cutting out the PCB outline in a 0.062'' (1/16th) clear acrylic sheet | I usually use the Dimension layer info to make a jig for silkscreening by cutting out the PCB outline in a 0.062'' (1/16th) clear acrylic sheet | ||
+ | |||
+ | Here is a LFCSP 16 (4mm on each side) cut out of 2 mil kapton as above | ||
+ | |||
+ | {{:laserinfo:lfcspkapton.jpg|}} |