This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
mdcpickandplace:tubes [2009/11/21 19:02] ladyada |
mdcpickandplace:tubes [2009/11/21 19:04] ladyada |
||
---|---|---|---|
Line 35: | Line 35: | ||
{{:mdcpickandplace:cuttubedone.jpg|}} | {{:mdcpickandplace:cuttubedone.jpg|}} | ||
+ | ===== Install tube ===== | ||
+ | |||
+ | {{:mdcpickandplace:tubeinplace_t.jpg|[[:mdcpickandplace:tubeinplace.jpg]]}} | ||
+ | |||
+ | {{:mdcpickandplace:tubeinplaceside_t.jpg|}} | ||
===== Program in chip feeder ===== | ===== Program in chip feeder ===== | ||
Line 43: | Line 48: | ||
{{:mdcpickandplace:chipfeeder8soic.png|}} | {{:mdcpickandplace:chipfeeder8soic.png|}} | ||
- | Using the teaching camera, do your best to center the 8-soic part outline. The chips move a bit and we use bottom vision so this isn't critically important | + | Using the teaching camera, do your best to center the 8-soic part outline. The chips move a bit and we use bottom vision so this isn't critically important. Have the red dot indicate pin 1 - this will make it easy to program in the PCB parts orientation |
{{:mdcpickandplace:feederteach.png|}} | {{:mdcpickandplace:feederteach.png|}} |