This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
mdcpickandplace:tubes [2009/11/21 19:03] ladyada |
mdcpickandplace:tubes [2016/01/28 18:05] (current) |
||
---|---|---|---|
Line 4: | Line 4: | ||
It will result in a mess :) | It will result in a mess :) | ||
- | {{:mdcpickandplace:feederjam.jpg|}} | + | {{:mdcpickandplace:feederjam.jpg|}} <---- BAD! |
===== Modifying the tube ===== | ===== Modifying the tube ===== | ||
Line 34: | Line 34: | ||
{{:mdcpickandplace:cuttubedone.jpg|}} | {{:mdcpickandplace:cuttubedone.jpg|}} | ||
+ | |||
+ | ===== Install tube ===== | ||
+ | |||
+ | Install the tube so that it goes OVER the foam-padded bar and UNDER the unpadded bar | ||
+ | |||
+ | Place the tube so that the Phillips head screw is underneath the tube, this will help keep it in place. | ||
+ | |||
+ | Push the end of the tube all the way up to the metal stop plate. | ||
+ | |||
+ | {{:mdcpickandplace:tubeinplaceside_t.jpg|}} | ||
+ | |||
+ | {{:mdcpickandplace:tubeinplace_t.jpg}} | ||
+ | |||
===== Program in chip feeder ===== | ===== Program in chip feeder ===== |