This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
tutorials:knittingmachine:ftdicable.html [2010/11/01 22:46] ladyada |
tutorials:knittingmachine:ftdicable.html [2010/11/02 11:42] tek disambiguation using connector graphics |
||
---|---|---|---|
Line 76: | Line 76: | ||
This diagram assumes you're looking at the connector from the end that goes into the machine. Again, check with the photos many times to be sure you get this right! | This diagram assumes you're looking at the connector from the end that goes into the machine. Again, check with the photos many times to be sure you get this right! | ||
- | {{ :tutorials:knittingmachine:cablediagram.gif |}} | + | {{ :tutorials:knittingmachine:connbott-adafruit-kmt.png |}} |
+ | |||
+ | {{ :tutorials:knittingmachine:conntop-adafruit-kmt.png |}} | ||
Next is the one tough part, you'll want to cut the green wire as close to the black sheathing. Then cut the red wire about in the middle and solder both green and red wires to the red wire so that you have two wire connections. See the following image: | Next is the one tough part, you'll want to cut the green wire as close to the black sheathing. Then cut the red wire about in the middle and solder both green and red wires to the red wire so that you have two wire connections. See the following image: |