User Tools

Site Tools


tutorials:knittingmachine:ftdicable.html

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
tutorials:knittingmachine:ftdicable.html [2010/11/01 22:46]
ladyada
tutorials:knittingmachine:ftdicable.html [2016/01/28 18:05] (current)
Line 76: Line 76:
 This diagram assumes you're looking at the connector from the end that goes into the machine. Again, check with the photos many times to be sure you get this right! This diagram assumes you're looking at the connector from the end that goes into the machine. Again, check with the photos many times to be sure you get this right!
  
-{{  :​tutorials:​knittingmachine:​cablediagram.gif  |}}+{{  :​tutorials:​knittingmachine:​connbott-adafruit-kmt.png  |}} 
 + 
 +{{  :​tutorials:​knittingmachine:​conntop-adafruit-kmt.png ​ |}} 
 + 
 +Pin 1 is black, pin 2 will be red, pin 3 will be green, pin 6 is orange, and pin 7 is yellow.
  
 Next is the one tough part, you'll want to cut the green wire as close to the black sheathing. Then cut the red wire about in the middle and solder both green and red wires to the red wire so that you have two wire connections. See the following image: Next is the one tough part, you'll want to cut the green wire as close to the black sheathing. Then cut the red wire about in the middle and solder both green and red wires to the red wire so that you have two wire connections. See the following image:
/home/ladyada/public_html/wiki/data/attic/tutorials/knittingmachine/ftdicable.html.1288651615.txt.gz · Last modified: 2016/01/28 18:05 (external edit)