This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
tutorials:make:adalight:index.html [2011/10/07 23:13] ladyada |
tutorials:make:adalight:index.html [2016/01/28 18:05] (current) |
||
---|---|---|---|
Line 50: | Line 50: | ||
- | The three jumper wires then connect to **ground**, **clock** and **data** pins on the Arduino. If using a “traditional” Arduino board (Uno, etc.), use Digital pin **13** for clock and **11** for data. For the ATmega 32u4 or Teensy boards, use **B1** for clock and **B2** for data. The ground wire can connect to any GND pin on the Arduino. | + | The three jumper wires then connect to **ground**, **clock** and **data** pins on the Arduino. If using a “traditional” Arduino board (Uno, etc.), use Digital pin **13** for clock and **11** for data. For the ATmega 32u4 or Teensy boards, use **B1** for clock and **B2** for data. For Arduino Mega, use pin **52** for clock and **51** for data. The ground wire can connect to any GND pin on the Arduino. |