This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
chumby:hackerboard [2010/08/28 20:27] ladyada |
chumby:hackerboard [2010/08/28 20:37] ladyada |
||
---|---|---|---|
Line 49: | Line 49: | ||
{{:chumby:chumbyftdi.jpg?500|:chumby:chumbyftdi.jpg}} | {{:chumby:chumbyftdi.jpg?500|:chumby:chumbyftdi.jpg}} | ||
+ | |||
+ | ===== Connect ===== | ||
+ | |||
+ | {{http://www.ladyada.net/images/arduino/rebootdriver.jpg}} | ||
+ | |||
+ | Plug in your FTDI cable, and install any drivers. See our instructions for driver installation for [[http://www.ladyada.net/learn/arduino/lesson0-win.html|Windows]], [[http://www.ladyada.net/learn/arduino/lesson0-mac.html|Mac]] and [[http://www.ladyada.net/learn/arduino/lesson0-lin.html|Linux]] | ||
+ | |||
+ | Once the driver is installed, verify the COM or tty port. For example, the COM port for our FTDI cable is COM34 (we have a lot of FTDI cables!). Open up a Serial Terminal program and connect to that COM or tty port at 115.2Kbps without hardware handshaking | ||
+ | |||
+ | {{:chumby:termconnect.gif|}} | ||
+ | |||
+ | Connect a 5V regulated supply into the chumby and your FTDI cable so that the black wire lines up with the **GND** labeled pin | ||
+ | |||
+ | {{:chumby:serialconnect.jpg?500|:chumby:serialconnect.jpg}} | ||
+ | |||
+ | You should see the following on your terminal: | ||
+ | |||
+ | {{:chumby:serialboot.gif|}} | ||
+ | |||
+ | Hit return a few times to get the shell! | ||
+ | |||
+ | {{:chumby:firstshell.gif|}} |