AdaWiki

{{ vimeo>15752459 }}

----

====== Parts list! ======


  * [[http://www.mcmaster.com/itm/find.asp?searchstring=5537T104 | 20mm Extrusion 2 ft piece]] (McMaster #5537T104) x **2 pieces** 
  * [[http://www.mcmaster.com/itm/find.asp?searchstring=5537T154|20mm Extrusion T-nuts]] (McMaster #5537T154) x **4 bags of 4**
  * [[http://www.mcmaster.com/itm/find.asp?searchstring=92137A412|Flange Button Head Cap Screw, M5 Size, 8 mm Length, 0.80 mm Pitch]] (McMaster #92137A412) x **1 bag**
  * [[http://www.mcmaster.com/itm/find.asp?searchstring=5537T181|20mm Extrusion 90 Degree Bracket, Single, 2-Hole]] (McMaster #537T181) x **4 pieces**
  * [[http://www.mcmaster.com/itm/find.asp?searchstring=5537T14|20mm Extrusion endcap]] (Mcmaster #537T14) x **4 pieces**
  * [[http://www.mcmaster.com/itm/find.asp?searchstring=8560K172&sesnextrep=343409141868956|Clear Cast Acrylic Sheet, .060" Thick, 12" X 24"]] (Mcmaster #8560K172) x **1 piece** 

Total is $50

====== Quick instructions ======

Cut the 20mm extrusion into ~18" pieces (make them a little shorter than the pick and place drawer.

Attach the pieces with L-brackets so that the L-brackets face each other on the inside of the holder and the outside right edge is flush with the drawer.
AdaWiki

User Tools

Site Tools

Page Tools
