This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
tutorials:products:bonebox [2012/01/28 07:56] pburgess |
tutorials:products:bonebox [2012/01/28 08:00] pburgess |
||
---|---|---|---|
Line 43: | Line 43: | ||
* Slide a nylon spacer over each of the four screws. | * Slide a nylon spacer over each of the four screws. | ||
- | * Slide the base plate over the screws. There's a specific orientation to this: one of the four alignment studs is smaller than the others — this should be positioned closest to the USB client port. | + | * Slide the base plate over the screws, coming to rest on the spacers. There's a specific orientation for the base plate: one of the four alignment studs is smaller than the others — this should be positioned closest to the USB client port. |
* Install four nuts and gently tighten each screw. | * Install four nuts and gently tighten each screw. | ||
Line 79: | Line 79: | ||
* Press the front face flush again and tighten all the screws. Acrylic is brittle, so don't crank these down too hard – finger pressure plus 1/8 turn is sufficient. Insert the microSD card (make sure it goes into the card slot, NOT loose in the case!). Bingo…you're done! | * Press the front face flush again and tighten all the screws. Acrylic is brittle, so don't crank these down too hard – finger pressure plus 1/8 turn is sufficient. Insert the microSD card (make sure it goes into the card slot, NOT loose in the case!). Bingo…you're done! | ||
+ | |||
+ | ====== Access ====== | ||
To access the board or cape later, it's not necessary to rewind this entire process — most of the parts can be left in place! Just loosen the front case screws 1/8", tip the front face back and pivot the case upward: | To access the board or cape later, it's not necessary to rewind this entire process — most of the parts can be left in place! Just loosen the front case screws 1/8", tip the front face back and pivot the case upward: | ||
{{ :tutorials:products:bonebox:fliptop.jpg?nolink& |}} | {{ :tutorials:products:bonebox:fliptop.jpg?nolink& |}} |