Check your kit!
Check to make sure your kit comes with the following parts.Sometimes we make mistakes so double check everything and email support@adafruit.com if you need replacements!
Parts list
Image |
Name |
Description |
Part information |
Qty |
|||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
 |
IC1 |
Microcontroller (preprogrammed when purchased in a kit) |
(unprogrammed when not purchased from Adafruit) |
1 |
|||||||
 |
IC1' |
8-pin socket | Generic | 1 |
|||||||
 |
X1 |
Stereo headphone jack | 1 | ||||||||
 |
R-LED, L-LED | 5mm Diffused Red LED | Generic | 2 |
|||||||
|
R3, R4 |
1/4W 5% 47 ohm resistor |
Generic | 2 |
|||||||
|
R1, R2 |
1/4W 5% 2.2K resistor Red, Red, Red, Gold |
Generic | 2 |
|||||||
 |
C1, C2 |
1.0 uF electrolytic capacitor 6V or greater voltage rating |
Generic | 2 |
|||||||
 |
ON/OFF |
6mm tactile switch | B3F-1000 | 1 |
|||||||
 |
ICSP |
6-pin ICSP header For advanced users who want to reprogram the microcontroller. Don't solder in until then! |
Generic | 1 |
|||||||
 |
BATT |
2 x AAA battery holder | 1 |
||||||||
|
PCB |
Circuit board |
1 |
||||||||
 |
Over-ear Headphones | 1 | |||||||||
 |
Safety Glasses | 1 | |||||||||
 |
Rainbow Ribbon Wire The rainbow type makes it easier to keep track of wires. |
1 ft | |||||||||
 |
4" Zip/wire ties These are bonus parts, in case you need them for securing the electronics to the glasses |
2 | |||||||||
| Heat shrink tubing 1/16" diameter | 4" | ||||||||||
 |
Paper Overlay | 1 | |||||||||
 |
AAA batteries | 2 |
